tag:blogger.com,1999:blog-2612020377307542483.post5892558113913579102..comments2024-03-26T15:22:02.198+00:00Comments on benchdonkees: I made a 3mm compression plate up today to stop the lovely new T140 piston colliding with stuff in the cylinder head. Put the primary drive back together too. Next job is to measure the combustion chamber with the piston in it, and work out the compression ratio.Darrenhttp://www.blogger.com/profile/01491964187453677511noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-2612020377307542483.post-29494394538214203202014-07-19T09:25:35.939+01:002014-07-19T09:25:35.939+01:00You too Ed, you too!You too Ed, you too!andyrotaxhttps://www.blogger.com/profile/04774571773329662566noreply@blogger.comtag:blogger.com,1999:blog-2612020377307542483.post-5932940759459595122014-07-19T08:44:49.115+01:002014-07-19T08:44:49.115+01:00Andy your a busy man ! the blog is great keep the ...Andy your a busy man ! the blog is great keep the good work up,,,,edhttps://www.blogger.com/profile/16379331578525009551noreply@blogger.comtag:blogger.com,1999:blog-2612020377307542483.post-19332283629594860712014-07-18T22:46:01.144+01:002014-07-18T22:46:01.144+01:00Out of some 3mm ally with a drill, hacksaw and qui...Out of some 3mm ally with a drill, hacksaw and quite a bit of filing!andyrotaxhttps://www.blogger.com/profile/04774571773329662566noreply@blogger.comtag:blogger.com,1999:blog-2612020377307542483.post-54765214824568030242014-07-18T17:30:36.119+01:002014-07-18T17:30:36.119+01:00How did you make that? How did you make that? OILY RAGhttps://www.blogger.com/profile/03813325676525697656noreply@blogger.com