benchdonkees: I made a 3mm compression plate up today to stop the lovely new T140 piston colliding with stuff in the cylinder head. Put the primary drive back together too. Next job is to measure the combustion chamber with the piston in it, and work out the compression ratio.

Thursday, 17 July 2014

I made a 3mm compression plate up today to stop the lovely new T140 piston colliding with stuff in the cylinder head. Put the primary drive back together too. Next job is to measure the combustion chamber with the piston in it, and work out the compression ratio.

4 comments:

OILY RAG18 July 2014 at 17:30
How did you make that?
ReplyDelete
Replies
ed19 July 2014 at 08:44
Andy your a busy man ! the blog is great keep the good work up,,,,
ReplyDelete
Replies

Subscribe to: Post Comments (Atom)